Another Steam Plant PART 4

Continued from p.776 M.E.4757 November 29 In the previous part of this article on the assembly of a model steam plant with an electric boiler, all the components that were assembled and tested on the dummy board were dismantled and re-assembled on the part-finished base shown in photo 34. You can see the surface of the base board has been covered in a vinyl tile which should be easy to clean and stop any water from soaking into the base. The dynamo can be seen fixed in place to the right of the engine fly wheel and a 12 volt led lamp has also been included. The drains for the boiler blow down valve and condenser have beenfitted as shown in photos 35 and 36. The electric boiler plug and…

You're reading a preview of

Model Engineer (Digital) - 1 Issue, Issue 4758

DiscountMags is a licensed distributor (not a publisher) of the above content and Publication through Zinio LLC. Accordingly, we have no editorial control over the Publications. Any opinions, advice, statements, services, offers or other information or content expressed or made available by third parties, including those made in Publications offered on our website, are those of the respective author(s) or publisher(s) and not of DiscountMags. DiscountMags does not guarantee the accuracy, completeness, truthfulness, or usefulness of all or any portion of any publication or any services or offers made by third parties, nor will we be liable for any loss or damage caused by your reliance on information contained in any Publication, or your use of services offered, or your acceptance of any offers made through the Service or the Publications. For content removal requests, please contact Zinio.